A network administrator attempts to improve multicast traffic flow and performs some packet captures for validation. What can the network administrator conclude from the results?

In a WLAN network with a tunneled SSID, you see the following events in HPE Aruba Networking Central:

The customer asks you to investigate log messages. What should you tell them?

An engineer has applied the above configuration to R1 and R2. However, the router's OSPF adjacency never progresses past the "EXSTART/DR" state.

Which configuration action on either router will allow R1 and R2 to progress past the "EXSTART/DR" state?

Exhibit.

A customer is reporting mat connectivity is Tailing for some wireless client Devices. What are your conclusions from the capture? (Select two.)

A customer would like to allow their IT Helpdesk to configure IoT devices to connect to a single SSID using a unique PSK that other devices cannot use.

Which solution would you recommend?

Exhibit.

After configuring VRRP between sw-1 and SW-2. you notice that both switches are showing as active. What could be the reason for this issue?

You are troubleshooting a WLAN deployment with APs and gateways set up with an 802.1X tunneled SSIO. End-users are complaining that they can’t connect to die enterprise SSID. Which possible AP tunnel states could be the cause of the Issue? (Select two.)

A customer's infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices. What is a valid cause for having an equal split in APs connected to the primary and secondary gateway clusters?

You created a new SSID with the security settings shown in the exhibit.

Some, but not all users complain that client devices are unable to connect to this SS1D. What is the reason for this?

An ACME company employee complained about a recent poor-quality VoIP call while moving around their office environment. HPE Aruba Networking Central reported a fair UCC score for this call while your VoIP engineer reported that their systems reported a MOS of 2.3. The VoIP devices are operating over the 5GHz frequency band.

What are the possible contributing factors? (Select two)

Exhibit.

Which would explain this issue?

You are tasked with developing a comprehensive, flexible, and survivable zero-trust wired access network using CX 6300 switching and HPE Aruba Networking ClearPass Policy Manager. Match the scenario to the special roles to achieve your objectives.

Refer to the exhibit.

You have recently implemented a VoWiFi solution with QoS, but users are experiencing poor call quality during busy periods. Based on the output generated after some test calls, what change should you make to improve call quality?

A customer’s infrastructure is set up to use Doth primary and secondary gateway clusters on the SSID profile What is a valid reason for the AP to failover to the secondary gateway cluster?

After onboarding three new AOS-10 gateways using the full-setup method into the same HPE Aruba Networking Central group, a customer cannot log in to one of the gateways using the HPE Aruba Networking Central remote console due to an incorrect password.

What is causing this issue?

What directly affects the MCS used by wireless stations? (Select two.)

Which statement is true given the following CLI output from a CX 6300?

A customer is evaluating device profiles on a CX 6300 switch. The test device has the following attributes:

• MAC address = 81:cd:93:13:ab:31

• LLDP sys-desc = iotcontroller

The test device is being assigned to the ‘’lot-dev’' role However, the customer requires the "lot-prod’’ role be applied.

Given the configuration, what is causing the "iot-dev" role to be applied to the device'?

Your customer asked for help to apply an ACL for wireless guest users with the following criteria:

• Wi-Fi guests are on VLAN 555

• allow internet access

• only allow access to public DNS servers

• deny access to all internal networks except for any DHCP server

These session ACLs are already present in the CLI of the mobility gateway group:

You have access to the CLl. Which user role meets all the criteria?

A)

B)

C)

D)

A customer has recently deployed AP-615s at their new office and is wondering on which band the radios will operate with the default configuration after creating a tri-band SSID. What should you tell them?

in a WLAN network with a tunneled SSID. you see the following events in HPE Aruba Networking Central:

The customer asks you to investigate log messages What should you tell them?

A customer's infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices. Why do they have an equal split of their 144 APs across the primary and secondary gateway clusters?

Your customer’s employees connected to a wired network are complaining about a poor user experience. The customer has HPE Aruba Networking User Experience Insight (UXI) sensors deployed on their premises. These sensors have been running for multiple months. They are testing both the wired network (using the wired interface of each sensor) and the wireless networks. Your customer used the UXI dashboard to find the reason for the poor user experience. To find more details, the customer asked you to check the packet captures that have been downloaded from the sensors using the UXI dashboard.

From the .zip file downloaded from the UXI sensors, you checked the "datagrams" .pcap file, but you were not able to find any issues. How can you explain this?

A customer is planning to add loT devices that connect wirelessly to the existing 802.1X SSID. The customer will use HPE Aruba Networking ClearPass to authenticate the loT devices by MAC address but other devices will still need to authenticate by only 802.1X.

Refer to the exhibit.

The customer provided the current configuration and reported their non-IoT 802.1X devices are no longer able to connect. Which configuration change can be made to fix the issue?

Exhibit.

A university runs its own TV station in the city The IT department deploys a multimedia server so the TV productions can be sent out to the entire campus over the IP network using multicast-based communications in order to improve the bandwidth consumption. PlM sparse Mode and IGMP snooping features are enabled.

When wireless users join the multicast groups, all users connected to the same WLAN experience poor network performance. However, wired users are not affected in this way While troubleshooting the network administrator saves the packet captures shown in the exhibit and concludes that all users even those not joining the multicast group, receive the same multicast flow at slow speeds.

Which features should the network administrator enable to fix the problem?

A customer is installing CX 6300 switches, mobility gateways, and AP-635s.

The customer's VoIP system uses both wired and wireless handsets.

The handsets are configured to mark voice traffic using a DSCP value of 46.

The wireless handsets connect to a bridged SSID using WPA3-SAE.

What will allow the switch to honor the QoS mark set by the handset?

Refer to the CLI output below:

What statement about the output above is correct?

A customer is evaluating device profiles on a CX 6300 switch. The test device has the following attribute:

• MAC address=81:cd:93:13:ab:31

The test device needs to be assigned the "lot-prod'' role, in addition the "lot-default" role must be applied for any other device connected lo interface 1/1/1. This is a lab environment with no configuration of any external authentication server for the test.

Given the configuration example, what is required to meet this testing requirement?

You recently added ClearPass as an authentication server to an HPE Aruba Networking Central group. RADIUS authentication with Local User Roles (LUR) works fine Out the same access points cannot use Downloadable User Roles (DUR).

What should he corrected in this configuration to fa the issue with DUR?

Exhibit.

Which statement is true?

A network administrator wants to configure an 802.1X supplicant for a wireless network that includes the following:

AES encryption

EAP-MSCHAPv2-based user and machine authentication

Validation of server certificate in Microsoft Windows 10

The network administrator creates a WLAN profile and selects the Change connection settings option. Then the network administrator changes the security type to Microsoft: Protected EAP (PEAP) and enables user and machine authentication under Additional Settings.

What must the network administrator do next to accomplish the task? (Select two)

Match each Group Based Policy (GBP) role description to its respective role ID.

The ACME company has an AOS-CX 6200 VSF switch slack with an uplink over subscription ratio of 9.6:1. They have indicated that their low-priority TCP traffic has been flagged with a DSCP marking coloring them yellow.

Refer to the exhibit.

They are considering adding two more nodes to the stack without adding any additional uplinks due to existing wiring constraints. One of their architects has suggested adding the following configuration:

What would be the impact of applying the acmethreshold profile as shown? (Select two.)

A network administrator accesses HPE Aruba Networking Central and notices that visitors consume too much internet bandwidth starving employee traffic when accessing an external service. Therefore, the administrator wants to limit wireless bandwidth to 60 Mops in both directions among all users in the voice rote and no more than 10 Mops in both directions for YouTube traffic. Deep packet inspection, web content classification, and firewall visibility are enabled.

Which configurations are required to accomplish this task? (Select two.)

A)

B)

C)

D)

An existing AOS-10 wireless deployment is expanding its zero-trust wireless network to multiple locations. The requirement is to propagate role information to enforce group-based policies for wireless client traffic across all locations.

To achieve this goal, which must be configured in this infrastructure?

After onboarding three new AOS 10 gateways using the full-setup method into the same Central group, a customer cannot log in to one of the gateways using the HPE Aruba Networking Central remote console due to an incorrect password.

A network technician racked up two 9240 mobility gateways in a single cluster that will be terminating 1700 APs in a medium-sized branch office Next, the technician cabled the gateways with two SFP28 Direct Attach Copper (DAC) cables, distributed between a two-member core switching stack and powered them up.

What must the network administrator do next regarding the gateway configuration to ensure maximum wired bandwidth utilization?