HSC - Transmission
Last Update May 6, 2024
Total Questions : 326
We are offering FREE H35-260 Huawei exam questions. All you do is to just go and sign up. Give your details, prepare H35-260 free exam questions and then go for complete pool of HSC - Transmission test questions that will help you more.
Which of the following descriptions of the electrical layer multiplexing and mapping steps of ODU0 is wrong?
When the data link layer of a router (IP forwarding) receives a packet whose length is greater than the maximum MTU of the interface that the router will send out, which of the following strategies is adopted?
The multi-level connection monitoring mode (TCM) of OTN has three application forms. Which of the following is correct?
Which of the following items belong to the debugging work of the playback system?
Which of the following queue scheduling mechanisms can ensure the priority of the most urgent and critical services?
Which of the following descriptions about bit errors in the SDH network is wrong?
Among the maintenance signals at the ODUk level, which of the following maintenance signals are included in the STAT bits of PM and TCM?
Which of the following network element forms supports the functions of branch and line, cross-multiplexing between lines and lines, and service adding and dropping functions?
When enabling NE performance monitoring events on the U2000 network management system, which of the following options are correct?
Set up the alarm to report automatically, and report the alarm on the device side immediately after the alarm is generated. The alarm board pops up on the network management system. The user can view the alarm information in the alarm board, and does not need to
actively search for words. Unnecessary alarms can be set to not be automatically reported. At this time, the alarm will no longer be reported to the network, even if the synchronization operation is performed.
The ETH_UWK_DOWN alarm indicates that the network port connection is faulty. The possible reasons do not include which of the following?
Which of the following logical function blocks is used for multiplexing section switching?
DCM optical power debugging requires the input of DCM to be no greater than which of the following values?
In the PTNLTE solution, which source interface is used when deploying multi-hop daily BFD at the core L3 nodes in the prefecture and city?
Regarding PW labels and tunnel labels, which of the following statements are correct?
In the OSN6800 subrack, when the OTU is inserted in the 17th slot, electrical layer scheduling can be realized
After a certain distance transmission in the wavelength division system, the optical signal-to-noise ratio of the signal at the receiving end will decrease to a certain extent. The main reason is which of the following?
In the WDM transmission system, the main factors that affect the unevenness of the power balance of each channel do not include the following?
PTN can support in-band DCN. At this time, the port needs to enable the DCN function. Therefore, in CES service, PTN setup cannot be managed by in-band
DCN.
Which of the following Ethernet port alarms is not a physical layer alarm, that is, LSR_NO_HTED has no correlation with it, and there is no suppression relationship?
Which of the following technologies is used in the dynamic BGP MPLS L3VPN to distinguish the same IP address in different VPNs in the BGP protocol?
IEEE 802.1Q defines the structure of VLAN tags, including TPID, PRI, CR, and VLAN ID. Which of the following is used to classify service
priorities?
When using OptiX Datacollector to collect data, it can be collected by network element, which means to collect the fault data of all boards below the network element, or it can be collected by single board to collect
the fault data of a single board under the network element.
Which of the following light source technologies does the 100GOTU board use?
The L3VPN routing of the PTN LTE network includes user-side routing and network-side routing. What are the items based on which VPN routing forwarding table is finally generated?
Which items belong to the optical layer path in the path hierarchy of the WDM network?
To determine whether the optical fiber lines and connectors on the wavelength division side are normal, which of the following loopback methods is most suitable?
Which of the following is not included in the function of the Inspector inspection tool?
During device initialization and commissioning, which of the following configuration descriptions is incorrect?
The EDFA erbium-doped fiber amplifier is a key component of the new generation of optical fiber systems. Which of the following options are correct for the description of its advantages?
Which of the following response modes is usually used when diagnosing unidirectional tunnel connectivity in a PTN network?
In the MPLS-TPOAM architecture of PTN equipment, what are the functions of network performance maintenance?
Through the northbound interface, the U2000 can flexibly connect with different third-party network management systems, providing physical storage and reporting data information for the upper-layer network.
Which of the following statements about the internal port attributes of an Ethernet board is incorrect?
Which of the following optical loss alarms will not cause service interruption?