You are designing a traffic monitoring and analysis system for a customer. Which traffic monitoring technique would you recommend to place the amount of burden on the network infrastructure?

The service provider that you work for wants to offer IPv6 internet service to its customers without upgrading all of its access equipment to support IPv6, which transition technology do you recommend?

An enterprise customer has a national WAN network based on DMVPN over the Internet, with sites located throughout the country. The customer has recently deployed VoIP throughout the entire network , and users report that it takes up to 2 seconds to establish a telephone call to an IP telephone at another office network. Drag and drop the root cause and the corresponding design solution from the left onto the correct targets on the right Not all options are used

Your client is considering acquiring a new IPv6 address block so that all Ethernet interfaces on the network receive addresses based on their burned-in hardware addresses, with support for 600 VLANs. Which action do you recommend?

Which two techniques are used in an OSPF network design to slow down the distribution of topology information caused by a rapidly flapping link? (Choose two)

Which option describes a design benefit of root guard?

Refer to the exhibit.

Which routing solution is the most scalable to connect the branches to the HQ and to connect the branches together over the internet using DMVPN?

Which OSPF design consideration, with regards to simplicity and address preservation, must be considered when connecting two Layer 3 switches directly using 10 GBASE-T cabling and formatting an OSPF neighbor adjacency?

In a routed access hierarchical campus design, the access-to-distribution Layer 2 uplink trunks are replaced with Layer 3 point-to-point routed links. Why is it recommended that VLANs are confined on a single access switch rather than span across multiple access switches?

A BGP route reflector in the network is talking longer than expected to converge during network changes. Troubleshooting has shown that the router cannot handle all the TCP acknowledgements during route updates. Which action can be performed to tune device performance?

In a VPLS design solution, which situation indicates that BGP must be used instead of LDP in the control plane?

Drag and drop the Fast ReRoute mechanisms on the left to the correct routing protocols on the right. Not all options are used.

Which two statements regarding to QoS marking are true? (Choose two)

Which are two open-source SDN controllers? (Choose two)

A very large enterprise customer is migrating from EIGRP to IS-IS .What is your main concern in regards to change in the path packets take after the migration is complete?

Which two IoT use cases require the low latency and high reliability that 5G networks provide?

A network engineering team is in the process of designing a lab network for a customer demonstration. The design engineer wants to show that the resiliency of the MPLS traffic Engineering Fast Reroute solution has the same failover/failback times as a traditional SONET/SDH network (around 50MSEC). In order to address both link failure and node failure within the lab typology network, which type of the MPLS TE tunnels must be considered for this demonstration?

An enterprise network has two core routers that connect to 200 distribution routers and uses full-mesh iBGP peering between these routers as its routing method. The distribution routers are experiencing high CPU utilization due to the BGP process. Which design solution is the most effective?

A data center deign requires monitoring of their business critical voice and video services accessed by remote locations. Which two items are applicable? (Choose two)

Refer to the exhibit.

An enterprise has three sites over a Layer 2 Metro Ethernet ELAN service. 100Mb/s and 10 Mb/s links have been provisioned to provide redundancy for the head office. When OSPF routing enabled to provide connectivity and the correct bandwidth statement has been applied to each interface, the branch sites observe two equal-cost routes to the head office. The enterprise wants to send all traffic through the 100 Mb/s link and use the 10Mb/S link strictly as a backup. Which OSPF network type must be set to ensure that the head office 100 Mb/s circuit is preferred over the 10 Mb/s circuit, at the same time minimize the amount of configuration required on all of the routers throughout the network?

What is an implication of using route reflectors in an iBGP topology?

Refer to the exhibit.

Company ACME is adding a Cisco TelePresence system for real-time collaboration and wants to ensure the highest user experience. Drag and drop the necessary QoS mechanisms from the left to the right in any order. Not all options will be used.

You are designing a new data center network. Drag and drop new data center requirements on the left into the appropriate design principle on the right.

Which two options must be part of your network design to support dynamic mutual redistribution between multiple OSPFv2 and IS-IS boundaries, to avoid suboptimal routing? (Choose two)

At which two networks points is route summarization supported? (Choose two)

There is an MPLS-enabled link constantly flapping on an MPLS VPN network. Given that the network runs OSPF as the IGP protocol, which design mechanism will stabilize the network and avoid constant re-convergence?

Refer to the exhibit.

This Layer 2 ring has 10 VLANs with 1000 MAC addresses in each VLAN. Which protocol or mechanism provides the shortest traffic outage if the link marked with “X” fails?

An network is designed to use OSPF to reach eBGP peers. Which condition should be avoided in the design to potentially prevent the eBGP peers do not flap continuously in case of link failure?

Which two are IoT sensor-specific constraints? (Choose two)

Which two options are Loop-Free Alternate design considerations? (Choose two)

You are designing dual-homed active/active ISP connections from an enterprise customer for internet services, and you have recommended BGP between the customer and ISP. When three security mechanisms do you enable to secure the connection? (Choose three)

You are redesigning a high-speed transit network due to congestion-related issues. Which congestion avoidance mechanism can you apply to the existing network?

Refer to the exhibit.

Each branch network must connect to the HQ and other branch networks over the phase 2 DMVPN network using a single tunnel interface. OSPF is running over the DMVPN network. Which network type is compatible with the DMVPN tunnel and ensures that the next hop of any route is unchanged?

You have been asked to design a wireless network solution that will implement context-aware services on an existing network that was initially deployed for data traffic only. Which two design principles would you follow to increase the location accuracy with the least possible impact on the current setup? (Choose two.)

What are three common objectives of customers using multiple cloud providers? (Choose three )

Refer to the exhibit.

ACME Mining has four data centers in Santiago, Cape Town, Mumbai, and Beijing. They are full-mesh connected via a 400 Mb/s EVP-LAN. A 1-TB transfer occurs daily via FTP between the Santiago and Mumbai data centers. When testing, the data transfer took an ''unexpected and outrageous, with an average transfer rate of 47 KB/s. The team provided this information.

LAN bandwidth usage below 5% at both data centers during transfer.

WAN bandwidth usage was between 20-30% at both data centers during transfer.

The only QoS on WAN is KB/s strict priority configured for other types of traffic.

There is no QoS on LAN.

The ping RTT average between data centers is 378 milliseconds.

Which action improves the file transfer rate?