Refer to the exhibit.

A user attempts to connect to 10.10.10.1.80 using FTP over SSL with an FTPS client. Which virtual server will match and attempt to process the request?

Assume the bigd daemon fails on the active system. Which three are possible results? (Choose three.)

Assume a client's traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are

left at their defaults. If the origin server were to initiate traffic via the BIG-IP, what changes, if any, would take place when the BIG-IP processes such packets?

A BIG-IP Administrator uses backend servers to host multiple services per server. There are multiple virtual servers and pools defined, referencing the same backend servers.

Which load balancing algorithm is most appropriate to have an equal number of connections on each backend server?

Refer to the exhibit.

How are new connections load balanced?

Refer to the exhibit.

A BIG-IP Administrator creates a new Virtual Server. The end user is unable to access the page. During

troubleshooting, the administrator learns that the connection between the BIG-IP system and server is

NOT set up correctly.

What should the administrator do to solve this issue?

Which event is always triggered when a client initially connects to a virtual server configured with an HTTP profile?

The BIG-IP Administrator needs to perform a BIG-IP device upgrade to the latest version of TMOS. Where can the administrator obtain F5 documentation on upgrade requirements?

A BIG-IP Administrator makes a configuration change to a Virtual Server on the Standby device of an HA pair. The HA pair is currently configured with Auto-Sync Enabled. What effect will the change have on the HA pair configuration?

A BIG-IP Administrator is setting up a new BIG-IP device. The network administrator reports that the interface has an incompatible media speed. The BIG-IP Administrator needs to change this setting

manually.

From which location should the BIG-IP Administrator perform this task?

Refer to the exhibit.

A BIG-IP Administrator needs to deploy an application on the BIG-IP system to perform SSL offload and

re-encrypt the traffic to pool members.

During testing, users are unable to connect to the application.

What must the BIG-IP Administrator do to resolve the issue?

When upgrading a BIG-IP redundant pair, what happens when one system has been updated but the other has not?

A 816-IP Administrator recently deployed an application Users are experiencing slow performance with

the application on some remote networks.

Which two modifications can the BIG-IP Administrator make to address this issue? (Choose two)

Which two statements are true about NATs? (Choose two.)

Interface 1.2 on a BIG-IP VE has a status of UNINITIALIZED. What is the reason for this status?

A configuration change is made on the standby member of a device group.

What is displayed as "Recommended Action" on the Device Management Overview screen?

A standard virtual server has been associated with a pool with multiple members. Assuming all other settings are left at their defaults, which statement is always true concerning traffic processed by the virtual server?

A BIG-IP Administrator needs to apply a license to the BIG-IP system to increase the user count from the

base license.

Which steps should the BIG-IP Administrator?

A site has six members in a pool. All of the servers have been designed, built, and configured with the same applications. It is known that each client's interactions vary significantly and can affect the performance of the

servers. If traffic should be sent to all members on a regular basis, which loadbalancing mode is most effective if the goal is to maintain a relatively even load across all servers?

During a maintenance window, an EUD test was executed and the output displayed on the screen. The BIG-IP Administrator did NOT save the screen output. The BIG-IP device is currently handling business critical traffic. The BIG-IP Administrator needs to minimize impact. What should the BIG-IP Administrator do to provide the EUD results to F5 Support?

A BIG-IP Administrator needs to have a BIG-IP linked to two upstream switches for resilience of the external network. The network engineer who is going to configure the switch instructs the BIG-IP Administrator to configure interface binding with LACP. Which configuration should the administrator use?

A BIG-IP Administrator suspects that one of the BIG-IP device power supplies is experiencing power

outages.

Which log file should the BIG-IP Administrator check to verify the suspicion?

Some users who connect to a busy Virtual Server have connections reset by the BIG-IP system. Pool member resources are NOT a factor in this behavior. What is a possible cause for this behavior?

Refer to the exhibit.

A BIG-IP Administrator configures the Virtual Server to pass HTTP traffic. Users report that they are

unable to access the application

What should the administrator do to resolve this issue?

Which Virtual Server type should be used to load balance HTTP traffic to a pool of servers?

Refer to the exhibit.

During maintenance, the BIG-IP Administrator manually disables a pool member as shown.

What is the result?

The BIG-IP Administrator generates QKView using tmsh command "qkview -SO". In which directory does the BIG-IP appliance save the QKView?

A BIG-IP Administrator needs to collect HTTP status code and HTTP method for traffic flowing through a

virtual server.

Which default profile provides this information?

Refer to the exhibit

The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a

configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the

servers on the new VLAN are NOT reachable from the BIG-IP device.

Which action should the BIG-IP Administrators to resolve this issue?

A BIG-IP Administrator is configuring an SSH Pool with five members.

Which Health Monitor should be applied to ensure that available pool members are monitored

accordingly?

What is the purpose of floating self-IP addresses?

A virtual server is configured to offload SSL from a pool of backend servers. When users connect to the virtual server, they successfully establish an SSL connection but no content is displayed. A packet trace performed on the server shows that the server receives and responds to the request. What should a BIG-IP Administrator do to resolve the problem?

Refer to the exhibit.

How many nodes are represented on the network map shown?

A site needs to terminate client HTTPS traffic at the BIG-IP and forward that traffic unencrypted. Which two are profile types that must be associated with such a virtual server? (Choose two.)

Which two statements describe differences between the active and standby systems? (Choose two.)

A BIG-IP Administrator creates an HTTP Virtual Server using an iApp template. After the Virtual Server is

created, the user requests to change the destination IP addresses. The BIG-IP Administrator tries to

change the destination IP address from 10.1.1.1 to 10.2.1.1 in Virtual Server settings, but receives the

following error:

The application service must be updated using an application management interface

What is causing this error?

When initially configuring the BIG-IP system using the config utility, which two parameters can be set? (Choose two.)

A BIG-IP Administrator needs to configure the BIG-IP system to perform load balancing for FTP servers

running passive mode FTP.

How should the administrator configure the Virtual Server to perform this load balancing?