When is an OSPF virtual link used?

What are three ways that VRRP is different from VRRP-E? (Choose three.)

You have configured your Brocade device as shown in the exhibit.

Brocade#sh ip

Switch IP address: 10.200.128.116

Subnet mask: 255.255.255.0

Default router address: 10.200.128.1

TFTP server address: 10.200.46.57

Configuration filename: Brocade

Image filename: None

IP MTU: 1500

Brocade#traceroute 10.200.128.1

Type Control-c to abort

Tracing the route to IP node 10.200.128.1 from 1 to 30 hops

1 <1 ms <1 ms <1 ms 10.200.128.1

Which statement is correct regarding interface Ethernet 10 on this device having inbound traffic from 172.17.1.1/24 to 172.17.2.1/24 on port 21?

A powered device connected to a Brocade FastIron device has been auto discovered and classified as a class-3 PoE device. However, its power consumption is only 10 watts. Which command would be used on the FastIron to reallocate power back to the available power budget, while still providing all the necessary power to the powered device?

You have a mission-critical application on your network that you know by IP address. You want this traffic to be serviced before all other traffic on the network. Which two features should you implement to ensure that this mission-critical application traffic is identified and serviced correctly? (Choose two.)

When configuring an IP static route in a Brocade router, which three parameters are required?

(Choose three.)

Which two statements about ICL links in Brocade Multi-Chassis Trunk (MCT) implementations are true? (Choose two.)

A customer wants to use a cable that provides maximum EMI protection. Which type of cable should be used?

What are two ways that TACACS+ differs from TACACS? (Choose two.)

You have to implement a security protocol that encrypts all traffic between the Brocade device and the authentication server.

Which security protocol would you use to support this requirement?

In a DR/BDR election, what will be the result for Router 1 based on the information shown in the exhibit?

You are configuring a keep-alive VLAN for a Multi-Chassis Trunking deployment on two new

Brocade MLXe chassis. You notice that STP and VLANs are not valid configuration options.

What have you overlooked during the configuration?

You have lost the super-user password to your Brocade device. You need to recover the device and bypass the password, using the serial console. Which command must you issue after you interrupt the boot sequence?

Which three parameters must match for two OSPF routers to become neighbors? (Choose three.)

Which two protocols would be used to back up a Brocade device configuration? (Choose two.)

Given the following configuration:

Brocade(config)# aaa authentication enable default radius tacacs telnet local

What is the primary authentication method being used for Privileged EXEC mode and CONFIG level access?